Speck-electronics X.Sum User Manual download pdf (Page 20)

PIN 2PIN 2

PIN 3PIN 3

PIN 4PIN 4

PIN 5PIN 5

PIN 6PIN 6

PIN 8PIN 8

Mix Out-A - LeftMix Out-A - Left

Mix Out-A - RightMix Out-A - Right

CommonCommon

Sum In- LeftSum In- Left

Sum In - RightSum In - Right

CommonCommon

PIN 1PIN 1

For Breakout BoxFor Breakout Box

For Link CablesFor Link Cables

Mix Out-B - LeftMix Out-B - Left

Mix Out-B - RightMix Out-B - Right

Link Out - LeftLink Out - Left

Link Out - RightLink Out - Right

CommonCommon

Link In- LeftLink In- Left

Link In - RightLink In - Right

CommonCommon

Chapter 3 Operation Section 16

Output

Connectors

15 16

Figure 5. Pin-outs for Multi-purpose I/O connector

12. Mix Output Jacks

13. Multi-purpose

I/O Connector

These balanced 1/4" TRS phone type connectors are the left and right outputs

for the stereo mix bus. The signal present at these jacks is adjusted by the Mix

Master Control [5] on the front panel.

The configuration for the ¼" TRS Mix Output Jacks are as follows:

Tip = High (+)

Ring = Low (-)

Sleeve = Ground

Figure 4. BB-03 combo breakout box

The multi-function I/O connector is used to connect the BB-03 Breakout Box

or link up to two additional X.Sum's.

The pin-outs for the multi-pupose I/O connector are shown below in Figure 5.

Note - All active-balanced output circuits of the X.Sum were designed for

balanced lines and should only be connected to balanced inputs. If

that is not possible and it is necessary to connect to an unbalanced

input, care must be taken not to connect the low (-) terminal to

ground. If the low (-) terminal of these outputs is connected to

ground, the result will be a high level of audio distortion.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Comments to this Manuals

No comments

Speck-electronics X.Sum User Manual Page 20

Comments to this Manuals

Related products and manuals for Audio Speck-electronics X.Sum